This has happened frequently to me on all versions of TR-Log for the past
four years, back to before 6.6X or so. It's like the bandmap window gets
refreshed partially or something. Whenever I see two identical bandmap
entries, always together in the bandmap, I know the display is messed up.
If I select one of them, I usually get a different bandmap entry. This
indicates to me that the display is out of sync with the actual bandmap
list. In any case, I just quickly change bands and then back again and the
bandmap display re-writes itself correctly.
73,
Ed - W0YK
> -----Original Message-----
> From: trlog-bounces@contesting.com
> [mailto:trlog-bounces@contesting.com] On Behalf Of VR2BrettGraham
> Sent: Wednesday, 14 March, 2007 02:52
> To: trlog@contesting.com
> Subject: [Trlog] 6.8latest bandmap
>
> I duped 9M4SDX today, even though the bandmap said it wasn't a dupe.
>
> I now have lost count how many times this has happened.
>
> I also can't say for certain when this behavior started.
>
> 9M4SDX was in the bandmap twice when this happened.
> I ^-end selected the one that showed the station was working
> split, but the radio was tuned by the program as if I had
> selected the non-QSX bandmap entry.
>
> These bandmap dupes (as in same call is in bandmap
> twice) are seen here from time to time, too.
>
> And until I enabled bandmap = all modes, from time to time
> when on SSB, there would be spots in the bandmap from below
> bandmap cutoff frequency & vice versa.
>
> Now either this is only happening to me or nobody else notices... ;^(
>
> 73, VR2BrettGraham.
>
> _______________________________________________
> Trlog mailing list
> Trlog@contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog
>
>
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|