Hi All:
Well, I should have left well enough alone.......I didn't
I need help getting my computer to see rig2 again. It used to. So what
changed? I added an Ethernet card which bumped the addressing
Now I can't seem to get the VESMUIO.CFG set right so the computer sees rig 2. I
get the following error message in TR: RADIO TWO polling disabled
I ran the VESHOW per the instructions to get my numbers
Origional VESMUIO.cfg string: S,A800,02E0,14,8,5 (WHICH WORKED BEFORE THE
ETHERNET CARD)
The new scring I came up with is S,B800,AC08,5,8,5. I changed the VESMUIO.cfg
string to this
Device manager shows COMM 5 address is AC08-AC0F and IRQ 5
I made the address correction in my TR config file (from 02E0 to AC08) as well
Now the Radio TWO polling disabled error message is gone but I still don't see
the rig 2 frequency.
I have the following command line in my autoexe.bat file
C:\VSEMUIO/VESMUIO.EXE C:\VSEMUIO\VESMUIO.CFG
Any help is greatly appreciated. I enjoy using TR on all CW contests and NAQP
is only a few days away.
Michael WG0M
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|