Kevin,
Thanks immensely-that did the trick!
Last question where and how do I put that statement so it executes on each
start up or reboot?
I really appreciate your taking time to think about this and help me out.
73,
Mike W9RE
-----Original Message-----
From: Kevin Schmidt [mailto:w9cf@arrl.net]
Sent: June 03, 2013 3:57 PM
To: Mike Wetzel
Cc: trlog@contesting.com
Subject: Re: [Trlog] IRQ's and 9600b
Mike,
I believe TR looks at the BIOS memory at 40:00 to find the port addresses.
If they are set to 0000 there, it uses the defaults. I would try
1. set Com4 to address $0260
2. run the command TR PORTS to see what TR thinks the com4 port address is.
If it thinks it is 2e8, then there is hope. Set the BIOS memory by hand
to $0260 using debug. That is type DEBUG then type
-e 40:06 60 02
-q
The - is the prompt. Then try TR PORTS again and see if it reports the
correct address.
73 Kevin w9cf
On Mon, Jun 03, 2013 at 03:07:58PM -0400, Mike Wetzel wrote:
>
> I believe TR only wants to see:
>
> Com1 IRQ4 3f8
>
> Com2 IRQ3 2f8
>
> Com3 IRQ4 3e8
>
> Com4 IRQ3 2e8
>
>
>
> When I set my Com4 to 2e8 the port is closed (most likely a conflict with
> the video board using this adr) and when I set Com4 to adr 260 TR will
not
> work even at 4800b (Hyper Terminal and the K3 utility program work fine).
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|