TenTec
[Top] [All Lists]

Omni 6 question/problem

To: <tentec@contesting.com>
Subject: Omni 6 question/problem
From: n1jm@dreamscape.com (John L. Merrill)
Date: Fri, 24 Jan 1997 06:14:24 -0500
scottb wrote:
> 
> Aurthur, I zero beat my Omni on WWV this way. Select LSB
> Using the wide 2.4 kHz filter, I defeat the AGC then I tune the PBT
> fully CCW. This way I get a nice beat note on WWVs carrier @ 10 Mhz.
> As you tune through their signal you will hear the "rumble" on either
> side of zero beat.  Right now my radio is about 100 Hz off and it
> isn't rock stable over time.  I tried to keep it perfect, but the
> temp in my basement shack isn't that stable.  I'm used to very
> expensive test equipment at work and I have to get used to the fact
> that this is ham gear, not laboratory test equipment !
> I've done lots of work on my OMNI and wouldn't trade it for anything !!
> The best technical description of the systems in the OMNI 6
> (better than manual for extreme tecnical) is in the ARRL Handbook
> chapter 17 199? ??  This helped me figure out all of the freq offsets
> that you refer to.
> Scott  W0KU   ex ND0V
Scott: I dont know how new yours is, but the newer OmniVI's had a mod so
that if you kept the power supply on it would keep the reference oven on
at all times even with the radio off, thereby reducing drift.

John

--
FAQ on WWW:               http://www.contesting.com/TenTecFAQ.html
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 w9tw@contesting.com
Sponsored by:             Akorn Access, Inc & N4VJ / K4AAA

<Prev in Thread] Current Thread [Next in Thread>