From: w1zn@ka2tcq
To: tentec@contesting.com
Hi
My Omni VI arrived back from Ten-Tec Friday May 30. After the upgrade
was complete the check of the receiver noted a sensitivity problem. It
went to the service dept and found an alignment problem with the 9Mhz
osc. The rig was completely aligned and tested. I am very pleased with
the upgrade. The NR circuit works very well. At time backround noise
The noise level drops to
a point that is very noticable. With very little effect on the received
negative effect on the
received signal. The button changes and menu changes make perfect sense.
The rig looks like new, and was the first time back to Ten-Tec in almost
5 years. Hope everyone else enjoys their upgrades and fine Ten-Tec gear.
73, Craig W1ZN
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|