TenTec
[Top] [All Lists]

[TenTec] 555 Scout Headphone Pad

To: <tentec@contesting.com>
Subject: [TenTec] 555 Scout Headphone Pad
From: dolledb@cet.com (Dennis B. Dolle)
Date: Mon, 21 Jul 1997 21:12:32 -0700
I have a Scout and would like to install a pad at the audio jack to allow
use of 8 Ohm stereo headphones.  Any recommendations out there for the
component values and installation techniques?  The manual just says to
install a pad, but gives no suggestions.  I've done this mod on other Ten
Tec rigs (Century 21, for example) but wonder if there is anything that I
should know about before putting the Scout under the knife.  I think I've
seen this information posted before, but couldn't find it during a one-hour
search of the archives.  Please forgive me if this thread has gone through
the needle before.

73s,

Dennis, NX5W

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm

<Prev in Thread] Current Thread [Next in Thread>