I have an Omni V which I just purchased used. I have 3 questions that I
would appreciate help with.
1) Is it the R46 resistor (100K) on 9Mhz board that you can change to a low
value (ie 1K or so) that will allow it to run down to 1/4 watt or so?
2) When using the headphones, with the rf and af gain controls down, it has
a whine which turns into a growl when tuning vfo, then whines again when
one stop tuning.
Is there a cure for this other than using my Omni C??
3) The matching P/S produces a hum in Omni V. I have it on an upper shelf
which does take care of most of it. Any cures?
Thanks for your help.
73, Bob, KQ7J
bens@valint.net
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|