TenTec
[Top] [All Lists]

[TenTec] Putting in 220 Filter installation

To: <tentec@contesting.com>
Subject: [TenTec] Putting in 220 Filter installation
From: wb4wen@hotmail.com (bill buchanan)
Date: Thu, 20 Aug 1998 11:38:09 PDT
Well guys, finally found a 220 8pole filter to put in the 525. Due to 
differences (skirts on 4 verses 8 pole) I will have to retune the 
oscillators I'm sure. Is this very involved? Oh, the offset is "Off 
center" as well, this requires I think adjusting vr1 on the control 
board?

Appreciate as always this reflector, ALMOST AS MUCH AS I APPRECIATE TEN 
TEC RADIO's, ALMOST!

73

Bill

______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Putting in 220 Filter installation, bill buchanan <=