My Ten-Tec Omni V has three filters in it that don't seem to bear the 2xx
series model numbers that I find in all the listings of crystal filters,
both at the Ten-Tec factory web site as well as the unofficial Ten-Tec site.
I wonder if someone here can confirm that they are what I expect them to be.
1. In the standard position (not the optional slot) in the 9 MHz IF board
there is an 8 pole filter that is marked: "48058 (OK) NS 9103". Is
this a model 220 2.4 KHz / 9 MHz filter?
2. In the 2.4KHz position on the 6.3 MHz Pass Band board there is an 8 pole
filter that is marked: "48074 NS (and then a number that is very hard to
read, it might be 8640)". Is this indeed a 2.4 KHz / 6.3 MHz filter? Is
there a 2xx series model number for this filter?
3. Finally, in the 1.8 KHz position on the 6.3 MHz Pass Band board there is
an 8 pole filter that is marked: "48074 NS 8903". Is this indeed a
model 288, 1.8 KHz / 6.3 MHz filter?
Thanks! Like others here have said, I sure appreciate all the knowledge and
helpfulness in this group! I've only been a subscriber a short time and
already several folks have been very helpful.
- Tom
_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
Tom Scott - Wyle Electronics - KD7DMH
10300 SW Nimbus Ave #PB, Portland, OR 97223
503-603-1931 - TEL 503-684-6620 - FAX
503-504-1583 - Cell 503-604-8651 - Pager
_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|