I recently picked up a Ten-Tec 262M power supply to use with my Triton
IV. I haven't wired up the power cable yet, but I did a preliminary
test on the power supply. I bridged the center switch leads on the four
pin molex output socket on back. I turned on the power supply switch,
the light behind the panel meter lit and I could hear the transformer
humming.
However, when I did a test of the output voltage at the molex plug on
back, I got no reading on my voltmeter. I checked voltage at the large
filter capacitor and got a reading of 24 volts.
This may be a dumb question, but shouldn't I be getting a 13 volt
reading at the output terminals, or is there some circuit breaker or
something in the output voltage circuit that I'm missing?
A schematic or manual copy would be helpful, if any of you have one.
I'm willing to pay copy and mailing costs.
73, Winston K4CWQ
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|