>Am I doing something wrong? The manual does not mention
>this. If this is normal, well I will be most upset.
>Any help would be greatly appreaciated.
>
>Thanks,
>Robb...N0RU
>
Robb,
I believe you need to check and verify that you have the TX
Enable and TX Out cables hooked up correctly between your Omni
and
Centurion. I don't have an amp, so am not fully up on the TX
Enable/Out operation, but looking at the schematic, Figure 4-18,
Control Board Schematic (81596), it looks like J2, TX
Enable, and J3, TX Out, must connected properly to work.
If the cables are reversed, it may not work.
Just a thought.
73,
dale, kg5u
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|