Duane:
I brought this up a while back. I can't remember the callsign, but a fella
sent me a file with the circuit to do it. However, it won't work in my
situation. I have a HercII built for Kachina, a KC500DC. Basically identical
except how it changes bands. The HercII requires a +12v signal, my KC500
requires a ground.
At any rate when I get home I'll send you the file so you can pass it on.
dacalvin@us.ibm.com wrote:
> For some reason my last post came back empty. I'll try again.
>
> There was a little discussion some time back about interfacing the Herc
> II's band select logic to the Yaesu FT-1000MP for those poor folk who have
> not yet discovered the Omni :^). Has anyone done this, or is anyone
> aware of either a kit or schematic for connecting the two together so the
> 1000MP would automatically select the correct band on the Herc II? This
> request is for a friend who is considering a Herc for his station.
>
> 73, Duane AC5AA
>
> Duane A. Calvin
> Server Systems Test Engineer
> Dept. 76TS RS/6000 - SP Nodes
> IBM Austin, TX >O< Tie: 793-3368
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|