TenTec
[Top] [All Lists]

[TenTec] Paragon "PLL Out of Lock"

To: <tentec@contesting.com>
Subject: [TenTec] Paragon "PLL Out of Lock"
From: patents@dx0man.prestel.co.uk (patents@dx0man.prestel.co.uk)
Date: Thu, 15 Apr 1999 00:47:16 +0100 (BST)
Just a thought - is your DC supply voltage a tad low for some reason
or other ?? I believe that lower than normal voltage can cause
strange problems in the PLL area. 

But the best bet has to be the advice about checking for bad
connections. I had a problem with my OMNI-V that only responded to
re-soldering in the VCO area to ensure that the screening box was
actually grounded all round. The area was also contaminated with
stray flux, some of it in hair-like strands. Its been OK for several
years now; I guess I welded the thing shut after all.

John G3JAG


On 13-Apr-99 Mike Woolverton wrote:
> Hello all and greetings from sunny Athens, Greece!!
> 
> I am the proud owner of a Model 585 Paragon, which I bought
> re-conditioned from the factory a few years ago.  Yesterday, the
> display suddenly started flashing "PLL OUT OF LOCK," along with the
> frequency I was on at the time.  I turned the rig off for awhile,
> then back on and all seemed to work fine.  I didn't give it another
> thought until this afternoon when about a minute after I turned the
> rig on, it went out of lock again.  I performed a re-set, hoping
> this would clear up the problem, but it didn't.  Since it is no
> small matter to return the rig to Ten-Tec for service (due to
> exorbitant mail costs, Customs, etc), does anyone have any
> suggestions??
> 
> Thanks and 73
> 
> Mike
> Michael W. Woolverton, MSG, USAF (Ret.)
> SV0AC/WB0ZPW
> sv0ac@otenet.gr
> 

----------------------------------
E-Mail: patents@dx0man.prestel.co.uk
To: <tentec@contesting.com>
Date: 14-Apr-99
Time: 23:43:12

COPYRIGHT means don't copy .....
----------------------------------

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>