The other solution is to be sure to get them to include instructions for
removing the PTO from the rig. On the Omni-C, that isn't hard if you know
what to take loose. Would be tougher if you didn't . . .
Regards, Mike N4NT@wireco.net
----- Original Message -----
From: Steve Ellington N4LQ <n4lq@iglou.com>
To: K & H Darwin <darwin@together.net>; TenTec List <tentec@contesting.com>
Sent: Sunday, October 03, 1999 9:58 PM
Subject: Re: [TenTec] Sticky VFO.
>
> The solution is to order a PTO rebuild kit from TenTec for about $25
> or so and follow the directions that come with it. After you've done
> one like this, you're an expert. If you are handy with electronics,
> you will have no problem.
>
> Steve N4LQ
> ----- Original Message -----
> From: K & H Darwin <darwin@together.net>
> To: TenTec List <tentec@contesting.com>
> Sent: Sunday, October 03, 1999 9:07 PM
> Subject: [TenTec] Sticky VFO.
>
>
> >
> > My new Omni C has VFO problems. I turn the knob but the VFO doesn't
> always
> > move. I assume this is that TenTec VFO problem y'all have posted
> about so
> > often. Until now, I simply ignored all those posts.
> >
> > So what was the solution again? Rebuild? Regrease? How difficult
> is the
> > task?
> >
> > Keith
> > KD1E
> > Ferrisburg, VT
> >
> > --
> > FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> > Submissions: tentec@contesting.com
> > Administrative requests: tentec-REQUEST@contesting.com
> > Problems: owner-tentec@contesting.com
> > Search: http://www.contesting.com/km9p/search.htm
> >
> >
>
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|