TenTec
[Top] [All Lists]

[TenTec] OMNI-VI+ RS232 connector

To: <tentec@contesting.com>
Subject: [TenTec] OMNI-VI+ RS232 connector
From: kg5u@hal-pc.org (Dale L. Martin)
Date: Sun, 24 Oct 1999 11:45:03 -0500
The DB-25 on the Omni VI is a female connector.

Here's what I did, Terry:

1.  Get three DB-25's; one male (pins), two female (sockets).

2.  Wire up one DB-25 female for the VFO.  Label the connector/cable
appropriately

3.  Wire up the second DB-25 female for the Computer.  Label the
connector/cable appropriately

4.  Wire both DB-25 females to the appropriate DB-25 male connector
pins.

Now, you have maximum flexibility and have made only about 16 or 20
solder joints.

73 and enjoy.




-----Original Message-----
From: 00tlzivney@bsuvc.bsu.edu <00tlzivney@bsuvc.bsu.edu>
To: tentec@contesting.com <tentec@contesting.com>
To: <tentec@contesting.com>
Date: Sunday, October 24, 1999 11:08 AM
Subject: [TenTec] OMNI-VI+ RS232 connector


>
>I have an OMNI-VI+ on order and want to make up the cable for the
computer
>control and remote VFO (301 kit) control.  What gender is the 25 pin
>connector on the back of the rig?  I got the pinouts from K4OJ's NCJ
>piece published last year but was unable to determine whether the rig
>had male or female so I could get the correct connectors.
>
>Thanks.
>
>Terry Zivney, N4TZ/9
>n4tz@arrl.net
>
>--
>FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
>Submissions:              tentec@contesting.com
>Administrative requests:  tentec-REQUEST@contesting.com
>Problems:                 owner-tentec@contesting.com
>Search:                   http://www.contesting.com/km9p/search.htm
>
>





--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>