TenTec
[Top] [All Lists]

[TenTec] Hot Heat Sink on Omni 6+

To: <tentec@contesting.com>
Subject: [TenTec] Hot Heat Sink on Omni 6+
From: vbbond@ix.netcom.com (vbbond@ix.netcom.com)
Date: Sun, 31 Oct 1999 08:35:08 -0700
Folks:
     I just noticed something on my two-month old Omni 6+ that has me 
concerned. Yesterday, after tuning the Johnson Matchbox on 10 meters CW 
(I pre-set the controls from a chart and afterward send a dit or two to 
ensure the SWR is flat) I tuned around the band looking for some DX. I 
noticed as my hand brushed against the back of the rig that the rear 
heat sink was getting very hot and I had not even really transmitted! I 
immediately turned off the rig and let it cool down for a half hour or 
so. Later, I turned it on and once again (with no transmitting) the rear 
heat sink started to immediately heat up, once again getting quite hot. 
Checked 40 meters, same thing happened. Decided to leave rig off.
     I suspect something on the PA Board failed and I somehow have a 
problem now with the bias cutoff regulation function. The transmitter 
still functions fine with full output and proper IC readings. 
     I have a hunch my brand new rig is going to receive a vacation in 
Sevierville for a few weeks. Have others experienced this problem?  Any 
ideas, suggestions? Much appreciated.

     Vince/K7NA
     Carlsbad, Ca.

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>