TenTec
[Top] [All Lists]

[TenTec] 301 knob - TenTec logo

To: <tentec@contesting.com>
Subject: [TenTec] 301 knob - TenTec logo
From: bob.fairbairn@motorola.com (Bob Fairbairn)
Date: Tue, 23 Nov 1999 12:51:54 -0600
superglue
----- Original Message -----
From: <00tlzivney@bsuvc.bsu.edu>
To: <tentec@contesting.com>
Sent: Tuesday, November 23, 1999 12:34 PM
Subject: [TenTec] 301 knob - TenTec logo


>
> OK, I have now gotten my 301 kit encoder to function with my new OMNI VI+
>
> had a couple of minor glitches to solve - one was how to connect the wires
> to the little connector for the encoder - Dale pointed out that the wires
> need to be pressed into the connector so I used a fine-bladed screwdriver
> for that.   Then, the radio shack 4 conductor shielded cable several
people
> have recommended proved too big for me to get the cable clamp around.  I
> had to cut off a piece of the tab and shave the main body opening bigger.
>
> Now, the remote knob works fine.  However, how do I get the TenTec logo
> to stay on the box?  The two pins on the back of the logo don't just snap
> into the box, and they aren't threaded so that I use nuts.  What's the
> secret?
>
> Terry Zivney, N4TZ/9
> n4tz@arrl.net
>
> --
> FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm
>


--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>