Then, a short run of RG-174 could be used from the sample point
> out to an existing RCA jack on the rear panel. The "13.5V aux"
> jack appears
> to be one I'll never need. Too bad there's not a designated
> "spare" jack as
> Ten-Tec provisoned on the Pegasus. If isolation or leakage appears to be
> problematic, a simple "N" channel FET configued as a voltage
> follower could
> be placed adjacent to Q1 on the PBT board. Comments?
>
> -Paul, W9AC
>
Say, Paul, what about the DB-25 connector? There are open, unused pins
there. I haven't looked to see what the accessibility issue with it is, but
I always thought that when and if I ever decide to clean up the cable mess
that two Omni's, the computer, remote antenna switch, and two bandpass
filter boxes makes, consolidating everything (audio out, mic in, CW key in,
etc.) to the DB-25 might be a fun weekend project.
73,
dale, kg5u
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|