TenTec
[Top] [All Lists]

[TenTec] Corsair comments

To: <tentec@contesting.com>
Subject: [TenTec] Corsair comments
From: N4LQ@iglou.com (Steve Ellington)
Date: Wed, 9 Aug 2000 18:45:45 -0400
Doing that is like shifting gears when you have an automatic transmission.
You shouldn't have to ride the RF gain if the agc is working properly. Most
JA rigs have so much internal noise that it sometimes helps to back down the
RFG a bit to rest the ears. With the old TT rigs this noise isn't a problem
and enjoyable cw copy can be had with full RFG until someone wacks you with
a super strong signal.

Interestingly, the AGC cannot even be turned off on most of TT's older rigs.
I suppose they saw no reason to do so. Many of us remember the old tube
receivers which had no product detectors and no agc on cw or ssb. Those were
real ear blasters! Riding that RFG was in fact "the only way to go".
Steve
N4LQ
----- Original Message -----
From: "Dale L Martin" <kg5u@hal-pc.org>
To: "Ten-Tec Reflector" <Tentec@contesting.com>
Sent: Tuesday, August 08, 2000 11:05 PM
Subject: RE: [TenTec] Corsair comments


>
>
> > The cure is to put on the attenuator and/or back off on the RF gain
> > until the signal reads about half acale on the S meter.
> >
>
>
> You mean people don't back off on the RF gain as a matter of course?
>
> I've been doing it for years and years.  It's the only way to fly.
>
> Heck, I just did the NAQP CW contest the other day and looking back at the
> Omni VI's, both RF gains are at about 1 and 2 o'clock positions.
>
> 73,
> dale, kg5u
>
>
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/tentec
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com
>
>


--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>