TenTec
[Top] [All Lists]

[TenTec] my omni 6+ problem - need ur advice

To: <tentec@contesting.com>
Subject: [TenTec] my omni 6+ problem - need ur advice
From: rbdrake@erols.com (Richard B Drake)
Date: Mon, 18 Sep 2000 12:20:16 -0400
Goodness! There must have been some misunderstanding between you
and Paul because he surely knows that there are a number of relays
in the OMNI 6+.  Look at the schematic of the low pass filter
board (Figure 4-4 in the manual) and you will see no less than 13
relays including the T/R switch (K1). There are a couple more
relays lurking around on other circuit boards, though those are
not likely the cause of your problem. Also, when you key the rig,
don't you hear relays clicking? They are all reed relays which are
fairly quiet but still clearly audible. Could the problem be with
your external coax relay? Sure, it could be anywhere that causes
an impedance problem between your antenna and your tx/rx
circuitry. It could even be as simple as a loose or dirty coax
connector.

---
73, Rich - W3ZJ

> -----Original Message-----
> From: owner-tentec@contesting.com
> [mailto:owner-tentec@contesting.com]On
> Behalf Of Bob Mauro - PeopleNet
> Sent: Monday, September 18, 2000 11:30 AM
> To: tentec@contesting.com
> Subject: [TenTec] my omni 6+ problem - need ur advice
>
>
>
> I talked to Ten Tec and Paul Clinton of their service
> dept says the Omni
> 6+ has NO RELAYS in it!  Is that true?  i thought my
> problem may be a TR
> relay in the rig.  R there none in the Omni 6+??  U
> know, it might just be
> my old antenna coax switch.  u think that's a possibility?  as i
> mentioned previously,
> my receiver seems to drop out.  i hit the dit or dah
> paddle of my keyer
> and the RX pops back up.  Could that be a bad ant. coax
> switch maybe?
> that would be great.  i had the switch in line and have
> that rx drop out
> on all bands.  now i'm going straight to the antenna.
> perhaps i won't
> have that problem now.  i'm hoping.
>
> But a few of u folks said the omni 6+ had relays.  does
> it?  or doesn't
> it?  now i'm confused.
>
>    Bob Mauro, Mauro@Idt.Net      Amateur Radio Station KZ2G
>
> --------------------------------------------------------------
>    My DisAbility Website       http://idt.net/~mauro
>    My Amateur Radio Website    http://idt.net/~mauro/kz2g.html
>    My Levittown, NY Website
http://idt.net/~mauro/levittwn.html
   --------------------------------------------------------------
       If my IDT mail bounces, send it to kz2g@altavista.com


--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com



--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>