TenTec
[Top] [All Lists]

[TenTec] 705 low output again ....

To: <tentec@contesting.com>
Subject: [TenTec] 705 low output again ....
From: KF6ZZ@aol.com (KF6ZZ@aol.com)
Date: Fri, 22 Dec 2000 23:32:10 EST
Hey Bill --

  The reason you are having low output from your TT 705 desk microphone is 
due to a design flaw in its bias circuit.

The Primo  EM-60  ( EM-100 in the 1201 kit ) electret cartridge used in the 
705 requires 1.5 volts DC minimum to bias the JFET inside the electret well 
into the constant current region. 
Actually, 3 to 4 volts is much better.

  The existing TT design has way too much resistance (24K) in line with the 
electret such that it's bias voltage never rises much above .5 ~.6 volts DC; 
and the JFET never gets out of the constant resistance region, and 
consequently cannot develop adequate gain. 

  To fix your 705 mic, tack solder a 3300 ohm resistor across R11 ( which is 
22K now ). 

You will find that you will have plenty of output after this mod .

If you are interested in enhancing the low end freq response as well, 
increase C2 to .47 uf or larger.

Also you should verify that the 705 is being run on at least 7 volts by 
measuring its operating voltage at the M+ pad on the 705's printed circuit 
board.
Some older Corsairs have 10K behind the mic connector pin 4, which should be 
reduced to less than 68 ohms.

For archive refs on this see > > > >
<A 
HREF="http://lists.contesting.com/_tentec/200009/msg00038.html";>http://lists.c

ontesting.com/_tentec/200009/msg00038.html</A>

73,     - Phil    KF6ZZ

--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] 705 low output again ...., KF6ZZ@aol.com <=