| To: | <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Scout mechanical problems.... |
| From: | rohre@arlut.utexas.edu (Stuart Rohre) |
| Date: | Fri, 12 Jan 2001 17:18:21 -0600 |
Same as other Ten Tec ptos. If it gets wobbly on the air, clean out the old grease and make sure the bearings are good, and regrease. I prefer Dow 44 high temperature ball bearing grease, as it does not harden. Stuart K5KVH -- FAQ on WWW: http://www.contesting.com/FAQ/tentec Submissions: tentec@contesting.com Administrative requests: tentec-REQUEST@contesting.com Problems: owner-tentec@contesting.com |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Scout mechanical problems...., Bwana Bob |
|---|---|
| Next by Date: | [TenTec] RX-320 as a sub receiver for OMNI VI, Carl Moreschi |
| Previous by Thread: | [TenTec] Scout mechanical problems...., Bwana Bob |
| Next by Thread: | [TenTec] Scout mechanical problems...., w8au@sssnet.com |
| Indexes: | [Date] [Thread] [Top] [All Lists] |