New versions for my Pegasus and RX-320 software are now available.
Highlights of version 1.46 of my Pegasus software features the following:
1) Full RX-331/RX-340 support to work with the Pegasus in full transceive
2) Flexible 6 and 2 meter IF frequencies that allow the user to define
the IF
so that transparent transverter operation is now possible with any
6 or 2 meter transverter that has an HF IF frequency.
3) Added a "PTT" button option on the remote pod.
4) Added the option to use the pegasus "line out" as the normal
sound option instead of the speaker.
5) Added support to use a second Pegasus as a sub-receiver with the
primary Pegasus. This now results in the Pegasus being used with an
RX-320, RX-331, RX-340, or second Pegasus.
Highlights of version 1.13 of my RX-320 software features the following:
1) Added an option to allow the CIV computer address to be configurable.
This allows more the RX-320 software to be on the same C-IV bus as
logging software to provide more flexibility when using the RX-320
as
a sub-receiver with an Omni VI, Paragon II, or Omni V.9.
2) Added Spectrum sweep stop when the sweep is clicked.
3) Added support for any ICOM radio that supports the C-IV interface
to be use the RX-320 as a sub-receiver.
4) Added a "follow" button that causes the RX-320 to automatically follow
the transceiver it is operating with.
Carl Moreschi N4PY
Franklinton, North Carolina
n4py@earthlink.net
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|