| To: | <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] station monitor with omniVI |
| From: | ve3ios@servers.ca (Jeff Peacock) |
| Date: | Wed, 18 Apr 2001 18:03:03 -0400 |
Has anyone connected a station monitor to an Omni VI? I am not sure where the output would be from to monitor the audio output. The output on the rear panel says it is in parellel with the mic input. I was looking for more of an audio signal after that part of the input. Jeff ve3ios -- FAQ on WWW: http://www.contesting.com/FAQ/tentec Submissions: tentec@contesting.com Administrative requests: tentec-REQUEST@contesting.com Problems: owner-tentec@contesting.com |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Answers to some of your questions, pywacker@fuse.net |
|---|---|
| Next by Date: | [TenTec] Jupiter DSP version in Pegasus emulation mode?, pywacker@fuse.net |
| Previous by Thread: | [TenTec] Answers to some of your questions, Stuart Rohre |
| Next by Thread: | [TenTec] Jupiter DSP version in Pegasus emulation mode?, pywacker@fuse.net |
| Indexes: | [Date] [Thread] [Top] [All Lists] |