If it were black and white at the same time, that would indicate that the
state of the bit was indeterminate, which isn't good for a low BER. If it's
going to be black and white, it needs to be completely black or completely
white at any given time.
73,
Mark
----- Original Message -----
From: "Mike Hyder - N4NT -" <N4NT@chartertn.net>
To: <tentec@contesting.com>; "Dave Kamp, KW0D" <kw0d@netexpress.net>
Sent: Thursday, February 07, 2002 5:41 AM
Subject: Re: [TenTec] Control software for Omni VI...
> black and white
>
> Mike
>
> ----- Original Message -----
> From: "Dave Kamp, KW0D" <kw0d@netexpress.net>
> To: <tentec@contesting.com>
> Sent: Wednesday, February 06, 2002 10:47 PM
> Subject: [TenTec] Control software for Omni VI...
>
>
> > Hi All!
> >
> > Anybody have recommendations for rig-control software? I'm considering
> > LOGic and TRX-Manager combination, but not very in-the-know about
> > computer-controlling and logging.
> >
> > At the moment, I'm looking for something free... so I can at least test
my
> > cable and make sure it's working properly...
> >
> > By the way... my cable has no dots on it, so I may have an interface
> > problem. If so, I've got a few stick-on dots I'll try, and once I find
> the
> > color that works, I'll paint it on permanently. What color dot should
> > promote the lowest Bit Error Rate?
> >
> > DK :-)
> >
> > 73's from KW0D Dave
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|