Chris,
That is a great suggestion for the Jupiter. However, at present,
there are no commands to read or write the memories in the Jupiter
to the PC.
And there are no memories at all in the pegasus. The PC program
becomes the memories for the Pegasus. If you were to run your
Jupiter in "Pegasus Emulation mode", then the PC program that you
were using would remember all the settings and memories for you
without them residing in the Jupiter. They would just reside in the
disk space of the PC.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "Chris Robson" <crobson@robsonco.com>
To: <tentec@contesting.com>
Sent: Friday, April 12, 2002 11:25 PM
Subject: [TenTec] Saving memories on Jupiter
> Hi all.
>
> Here is a potential upgrade for the Jupiter users. I would like to dump my
> memories to my computer so that when we get an upgrade and have to do a
> reset, the memories can be loaded back in via the serial port. If we can
> load updates, certainly there should be a way to do the same for our
> memories that we loose every time we reset. I realize this might be
> possible in the Pegasus, but why not the Jupiter.
>
> 73, Chris KB3A
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|