TenTec
[Top] [All Lists]

[TenTec] N4PY Pegasus/Jupiter/RX350 Control Program Version 2.00

To: <tentec@contesting.com>
Subject: [TenTec] N4PY Pegasus/Jupiter/RX350 Control Program Version 2.00
From: rich@1967z28.com (Rich McCabe)
Date: Sat, 1 Jun 2002 09:43:45 -0500
Thanks Carl,

I love it ! Do other Pegasus owners really use the original software and not
the N4PY software?

I can't imagine.

Rich


----- Original Message -----
From: "Carl Moreschi" <n4py@earthlink.net>
To: "tentec" <tentec@contesting.com>
Sent: Saturday, June 01, 2002 7:13 AM
Subject: [TenTec] N4PY Pegasus/Jupiter/RX350 Control Program Version 2.00


>
> Version 2.00 of my Pegasus/Jupiter/Rx350 Control Program
> is now available.  Version 2.00 features the ability
> to configure 114 different user options directly from
> the settings menu.  There are 16 submenus under the settings
> menu that allow you to set these options.  Previously,
> direct modification of the pegasus.ini file was required
> to change these options.  Having all these options gives
> YOU the ability to make the radio work the way you want
> it to.
>
> Also new for version 2.00 is the ability to use the RX350.
> This also includes saving and restoring the memories of the
> RX350.  This give RX350 users good frequency agility and
> direct frequency entry without the remote pod.
>
> Also new is the ability to use the Jupiter while the Jupiter
> is in front panel control mode.  This will allow my software
> to act as a "logging" agent to export the Ten-Tec file interface
> while the Jupiter is in front panel control mode.  With the
> file interface, you can then run any logging software you want
> that supports the Pegasus.  You just configure your logging
> software for a Ten-Tec pegasus, and run my software at the same
> time in "Jupiter Logging mode Only".  Also included is the
> ability to save and restore the Jupiter memories.
>
> Version 2.00 also features the option to remove the main tuning
> knob from the radio screen and replace it with buttons that
> allow direct manipulation of either VFO and filter settings.
>
> Send me an email at n4py@earthlink.net for further details
> or go to www.ralabs.com/n4py
>
>
>
> Carl Moreschi N4PY
> Franklinton, NC
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>


<Prev in Thread] Current Thread [Next in Thread>