Yea but if you had saved $300 and bought a Pegasus then you couldn't have
run the Pegasus in Jupiter mode either and then where would you be? Of
course, you could have taken the $300 and bought a Triton IV which
requires no software and have 2 rigs....
-----Original Message-----
From: "Scott Johnson" <scott@wowpage.com>
To: <tentec@contesting.com>
To: <tentec@contesting.com>
Date: Wed, 9 Oct 2002 12:48:34 -0400
Subject: [TenTec] Jupiter software
> OK, here's a question I can't seem to find the answer to anywhere. The
> Jupiter programmer's guide says that there are two modes for
> controlling the
> radio.
>
> Pegasus emulation mode makes the Jupiter look like a Pegasus -- it uses
> the
> Pegasus command set and DISABLES the front panel, while Jupiter mode
> uses a
> separate Jupiter command set and DOES NOT DISABLE the front panel.
>
> Several people have written control software that takes advantage of
> Pegasus
> mode. Is there no oftware that uses Jupiter mode, so that I can retain
> front panel control and display? If I wanted my front panel disabled,
> I
> would have bought a Pegasus and saved $300. :)
>
> I tried the Jupiter-specific version of PegasusPlus, but it too puts
> the
> radio in Pegasus mode.
>
> Anyone know about something I missed? Any ideas appreciated.
>
> Scott
>
> --
> Scott Johnson (scott@wowpage.com) (s.johnson@klotzdigital.com)
> ICQ: 30730876 ICBM: N33 45 50.6 W84 49 31.3 (+- 3dB)
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|