Rich, to adjust the receiver filters, use the "bandwidth" knob; it'll adjust
from 8 Khz wide to something like 300 Hz (well, so it says, they are rather
wide filters skirts); to adjust the transmitter on SSB, press the menu
button, adjust the tuning know to select "TX FILTER BW" and adjust the
"MULTI" knob to the bandwidth you want. When you're adjusting that, make
sure you take the "TX ROLL OFF" adjustment (on the bottom of the menu) into
account.
73,
Joe, W2RBA
> -----Original Message-----
> From: tentec-admin@contesting.com [mailto:tentec-admin@contesting.com]On
> Behalf Of Rich McCabe
> Sent: Thursday, October 17, 2002 3:24 PM
> To: tentec@contesting.com
> Subject: [TenTec] Jupiter newbie question.
>
>
> Can't figure out how to adjust the filters on a Jupiter. When the
> button is pushed it shows the filter but no sure how to change it.
>
> This rig does not have a manual so kinda in the dark.
>
> 73,
>
> Rich
|