Hi Guys,
I know this is a bit off topic...
Several months ago I picked up a Tek Type 106 Square Wave Generator on
E-Bay (very cheap -- cost more to ship than the price of the auction).
The output connectors are GR-874 (hermaphroditic type). It requires a
special Tek 50ohm feed thru with a GR874 on one end, and a BNC on the
other; Tek # 017-0083-00. The two are designed to go with each other
because of the square wave timing. I'm sure there are other old Tek
units that require the same adapter.
I finally found the GR-874 to BNC 50 Ohm Feedthru Adapter(s) on E-Bay;
and I had to buy the lot, which is four of them. I need only one, so I
have three for sale. Please contact me if you could use one.
TEKTRONIX GR874 to BNC 50ohm term
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=1504&item=1790764481
Thanks for the intrusion.
Mark Hinkel WA3QVU
Willow Grove, Pa.
|