Hallo Alfred!
The links you mention are always needed if you want RF output from the
antenna socket.
They connect the driver stage to the final RF PA, removing them means that
you no longer have any RF out of the antenna socket on TX.
They are meant to be used with the Ten-Tec transverters, like 6N2 etc.
Do not worry, by leaving them in, you will not damage your amplifier.
I'm sorry, but I cannot wite this properly in German language, my German is
too poor!
Tschuss!
Paul MW0CDO
Alfred Heyden wrote:
> Hello TT-fellows,
> I run my Paragon II with a non-TT and non qsk amplifier. The rear
> jacks TX OUT/ TX EN
> are jumpered. I'm not quite shure if this is correct. Should I
> remove the jumper?
> The operator's manual tells me to leave this jumper in place for
> all operations general not
> using a RF linear. Means this to leave the jumper also in place
> when using an non-qsk-amp?
> I key the amp with the RELAY N.O. jacket.
> Thanks for your hints.
> With regards, Alfred, DL2JR
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|