Anthony,
I'm sorry I don't have any "technical" suggestions, but you might want
to open it up and make sure all million and one of the little plugs are
firmly in place. I've found they sometimes loosen up during shipment.
Hope that will solve your problem...good luck
Tony, W4FOA
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Anthony Bowyer
Sent: Sunday, February 16, 2003 5:56 PM
To: tentec@contesting.com
Subject: [TenTec] Omni V CW Problem
Just got my Omni V back from Ten-Tec Thursday of last
week which was in for check/alignment, and just tried
transmitting today, and noticed a problem on CW. Seems
QSK isn't QSK'ing! It's most noticable on dots. Power
drops down to near 0. ALC is lit as if it's
transmitting, but there's intermittent power drop
outs. I was making a few calls during the contest, and
getting strange responses. I wondered why and looked
at the watt meter, and this is why! Anyone had this
problem before? Any ideas would be appreciated!
Anthony, NT4X
=====
NT4X
__________________________________________________
Do you Yahoo!?
Yahoo! Shopping - Send Flowers for Valentine's Day
http://shopping.yahoo.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|