TenTec
[Top] [All Lists]

[TenTec] Argo V Transmit Audio - Part II

To: <tentec@contesting.com>
Subject: [TenTec] Argo V Transmit Audio - Part II
From: jmerrill1@adelphia.net (John L Merrill)
Date: Sun Mar 23 09:14:58 2003
I don't think this story proved anything other than you got the guy in
trouble. Apparently his settings were ok until someone changed them. If you
were working for me and I had found out you had done that trick, you may
have been fired, HI.

73,

John N1JM
Director of Engineering and Operations
WIVB-TV/WNLO-TV
Buffalo NY

-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Robert & Linda McGraw
K4TAX
Sent: Sunday, March 23, 2003 8:10 AM
To: tentec@contesting.com
Subject: [TenTec] Argo V Transmit Audio - Part II



>
> Here's a cute but true story regarding setting of knobs to a certain
> position.  I was working as a senior broadcast engineer for a TV station
in
> Nashville.  Each evening after sign off, we went through a procedure of
> video calibration.  This was to account for various level changes that
were
> required through out our operating day and to account for any drift or
aging
> of the tubes in the various pieces of equipment.  One evening, as the
> supervisor in charge, I assigned the task to a young engineer.  He
completed
> it in some 10 or 15 minutes much to my surprise.  A few weeks latter the
> same situation occurred except that I observed him simply setting knobs
and
> screwdriver adjustments to some pencil "pre marked" positions on the
various
> pieces of equipment.  I questioned him about this and he responded that "
> they are always the same and I'm in a hurry to get home".  Well as things
> would happen, a week or so latter, I carefully erased all the marks and
put
> on new marks.  Of course, nowhere near the correct positions.  In doing
this
> and knowing his work schedule, I set the trap for him.  I was not on duty
> that evening and I knew that the Chief Engineer would be at the
transmitter
> at the next morning at sign on.  I understand that he dutifully set the
> knobs on the "marks" and went home.  The next morning at sign on things
went
> rapidly "down hill" so to speak.  Video levels were high, video levels
were
> low, sync levels were askew and basically all over the place, level wise.
> A call from a very irate Chief Engineer to the studio that morning set
> things stirring and quickly things were corrected in a reasonable manner.
> That afternoon the CE called the young engineer that had done video
> calibration the evening before, into his office.  After discussing the
> events and the disclosing the fact that the CE just happened to find out
> about the "pre marks" a serious butt chewing took place.  A lesson learned
> that one fellow will never forget.  Nary again did "pre set" marks appear.
>
> 73
> Bob, K4TAX


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
---
Incoming mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
To: <tentec@contesting.com>
Version: 6.0.462 / Virus Database: 261 - Release Date: 3/13/2003

<Prev in Thread] Current Thread [Next in Thread>