At 02:10 PM 5/13/03 -0700, k6se@juno.com wrote:
>My new Orion is scheduled to be delivered Friday, May 16th. I've
>downloaded the operating manual and cannot find anything specific in it
>about supplying a continuous transmitter output, needed for tuning up a
>linear amplifier.
The TUNE button on the transceiver allows keydown CW output.
Press TUNE, and the Orion sends keydown CW at a fixed value
(approximately 20 watts- usually used for antenna tuners, but can
also be used for initial amplifier tune up).
To have keydown CW output at whatever power level the Orion
is set for, press TUNE, and while the radio is transmitting, press
the PWR button. This will bump up output power to whatever
value has been set - and it then can be adjusted with the MULTI
knob at the same time.
Or, as was pointed out, you can use PTT while in CW mode to
key the radio at whatever set power output level you have.
Scott Robbins, W4PA
-----------------------------------------------------------------
Ten-Tec, Inc., 1185 Dolly Parton Pkwy, Sevierville, TN 37862 USA
Contact Mon-Fri Eastern: Office/Tech (865) 453-7172 9 am-5 pm.
Repair (865) 428-0364 8-4. Sales (800) 833-7373 9 am-5:30 pm.
Fax (865) 428-4483 24 hrs. Visit us at <http://www.tentec.com>
Email: New product sales/product info sales@tentec.com
Service department service@tentec.com
While we make every effort to answer email in an expedient manner,
the telephone is a much more efficient tool for getting a quicker and
more complete answer to your inquiries. Thanks!
|