I will be making a newer version of my software that will come out at the
end of this month. When the 60 meter band is selected, it will
automatically set the output power to 50 watts, set the ssb bandwidth to
2400 ( a much safer value), and the low cutoff to 200. When leaving the 60
meter band, it will restore these settings to what they were previously.
I will use 2400 hertz transmit ssb bandwidth because these are only the 6 db
power points of the bandwidth. The total bandwidth is actually much higher.
The FCC rules state all the bandwidth must be contained in 2800 hertz. I
actually think even the 2400 hertz bandwidth is more like 3200 at the 60 db
power points. So I hope the 2800 hertz rule is not strictly enforced
because I don't believe any transmitter today meets this value for total SSB
bandwidth.
Carl Moreschi N4PY
----- Original Message -----
From: "John T. Fleming" <W3GQJ@attbi.com>
To: <tentec@contesting.com>
Sent: Wednesday, June 04, 2003 1:38 PM
Subject: RE: [TenTec] Jupiter on 60Meters
> Carl's software is great. BUT be sure to change the settings if not
already
> changed to have a roll off at 200 Hz and a SSB band width of 2,600 Hz.
That
> will insure that you stay within the band width. The changes are in the
> Menu of the Jupiter. I set my width to 2,550 Hz, the closest setting to
> 2,600.
>
> 73,
> John
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of David W LeJeune, Sr
> Sent: Wednesday, June 04, 2003 12:27 PM
> To: tentec@contesting.com
> Subject: Re: [TenTec] Jupiter on 60Meters
>
> I just received the 60 mtr channelized .RMY file from Carl (N5PY). Seems
to
> work fine on 60 meters (ver 2.08 even has a 60 Meter button!)
>
> Dave
> ----- Original Message -----
> From: "Michael Pastorcich" <mpastorcich@hotmail.com>
> To: "TenTec" <TenTec@contesting.com>
> Sent: Wednesday, June 04, 2003 8:18 AM
> Subject: [TenTec] Jupiter on 60Meters
>
>
> > Has any one heard when/if TT will have a firmware update for the Jupiter
> to
> > operate on the new 60 meter allocations?
> >
> > 73,
> > Mike KF4HEY
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|