I've broken one or two knobs. The center tube that goes on the shaft broke
when I overtightened the setscrew. By putting a couple of book matches
between the tube and the outer part, I've been able to shore it up to
perform just like new (maybe even better).
73, Mike N4NT
----- Original Message -----
From: "Don Rasmussen" <wb8yqj@yahoo.com>
To: <tentec@contesting.com>
Sent: Sunday, June 29, 2003 11:38 PM
Subject: [TenTec] Need Corsair II knob!
> Hi Guys,
>
> Can anyone tell me where I can find a single front
> panel knob for the Corsair II mode control? It's the
> same one used for the AF Gain, OFFSET, and most of the
> other front panel controls. Any help on locating one
> of these would be greatly appreciated.
>
> 73 es thanks,
> Don Rasmussen WB8YQJ/6
> Carlsbad, Ca.
|