TenTec
[Top] [All Lists]

[TenTec] dbm and VU units of audio measurement

To: <tentec@contesting.com>
Subject: [TenTec] dbm and VU units of audio measurement
From: wlfuqu00@uky.edu (Bill Fuqua)
Date: Wed Jul 30 14:19:19 2003
At 12:32 PM 7/30/2003 -0500, you wrote:
>Lots of confusion abt how the dB standard has been applied and used over the
>years. My HP-606A SG uses the DBM range referencing 0db=10 dB below 1V (.3V)
>into a 50 Ohm load. This has been a standard for some years, but impedance
>can throw a curve.


Some generator dB Megawatt
I remember someone asking me what mmfd was. He had a very old schematic 
diagram.
I said "it is milli-milli-femto-deci and when it gets that small the units 
really don't matter".
Then I told him that it was an old notation for pF.
All the computer ads have  millihertz CPUs (mhz)

Sorry, just could not resist.

I get prescriptions from the drug store that have so many MG dosage printed 
on the label.
You would think they would know the difference.

OOPS now I am on a roll.

You know that there were no DB9 connectors until the Computer
community started calling DE9 connectors DB9. Then distributors had to 
change the name in
their catalogs to accommodate the computer guys and ultimately the 
manufacturers had to do the same.


73
Bill wa4lav


<Prev in Thread] Current Thread [Next in Thread>