TenTec
[Top] [All Lists]

[TenTec] Omni V PLL Board rework question

To: <tentec@contesting.com>
Subject: [TenTec] Omni V PLL Board rework question
From: wb2vuf@qsl.net (Bwana Bob)
Date: Mon Aug 11 21:19:32 2003
Frank:

Yes, reflowing the solder is definitely the fix. On my Paragon, I also
found some balun coils and electrolytic caps that were microphonic. I
coated the coils with clear nail polish and replaced the caps with
tantalum types.
                        
                                73,

                                Bob WB2VUF

Frank Ayers wrote:
> 
> Hi all
> Recently my Omni V has displayed an intermittent problem - while listening
> to a signal it will get very "watery" sounding and then go away all
> together. I called Tentec and the guy I spoke with seemed to thing it was a
> matter of the PLL unlocking (which is what it sounded like to me). He
> suggested that if I was willing to try repair myself, I should take out the
> PLL board and re-solder all the stuff around the osc can. It seems that
> there is compound in there that over time can cause problems from heating
> and cooling and that this a somewhat common occurance. Not that all rigs
> have it, but of those that do, the connection problem is the usual answer.
> My question - has anybody done this and is there anything that I should be
> on the lookout for? I would much rather fix this myself that ship it out and
> have UPS do the final stress test for me.
> 
> Frank
> W2FCA
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


<Prev in Thread] Current Thread [Next in Thread>