Hi John,
On my Omni VI the DSP noise reduction is toggled on and off by pushing
the "NR" button. The LED next to that button indicates the status. If
you mean via a computer on the RS-232 interface, I have not found any
reference to control of the DSP NR in chapter 5 of my manual. I also
find no mention of filter selection. Is there a way to control that,
other than front panel buttons?
Ken N6KB
I've managed to get just about every other function (VFO/mode) figured out,
but can't figure out how to toggle DSP on and off on my Omni VI/Opt 1
(should be the same as a VI+). Anyone have a clue?
If anyone needs the other commands let me know.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|