An added effect of impedance mismatching has to do not so much with "power"
transfer with mics but with frequency response. The classic D-104 - which I
used for many years and still have - sounded great with a hi-Z input. Feed
it into a low-Z input and all the highs disappear and you get the bassy,
slightly muddy sound we hear occasionally on the air.
So, two main effects: less output to drive the mic preamp circuitry and
decreased high-frequency response.
73/72, George
Amateur Radio W5YR - the Yellow Rose of Texas
Fairview, TX 30 mi NE of Dallas in Collin county EM13QE
"Starting the 58th year and it just keeps getting better!"
w5yr@att.net
----- Original Message -----
From: "Stuart Rohre" <rohre@arlut.utexas.edu>
To: <tentec@contesting.com>
Sent: Wednesday, October 29, 2003 3:21 PM
Subject: Re: [TenTec] Re: what is so special about heil microphone elements?
> Actually Bill, for mike use, you do not have to rigorously match the load
to
> the source impedance, if the load is as high as tube and early
semiconductor
> rigs were. You wanted the load to be higher than the impedance of the
mike.
> However, now, many circuits are set up for 600 ohm mike inputs, and load
> down the old higher impedance source crystal and dynamic mikes. The
> matching of impedances is used for power circuits like audio outputs while
> mikes are voltage source devices, not current sources like high power
audio
> output stages and RF circuits for output stages.
> 73,
> Stuart
> K5KVH
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|