TenTec
[Top] [All Lists]

[TenTec] Orion and MIKEs

To: tentec@contesting.com
Subject: [TenTec] Orion and MIKEs
From: K3BU@aol.com
Reply-to: tentec@contesting.com
Date: Thu, 6 Nov 2003 13:32:44 EST
List-post: <mailto:tentec@contesting.com>
One step further, looking at the diagrams in the new manual I get little 
confused:
Wonder if it is the cause of some audio problems reported earlier.

Page 9 shows Figure 2-3 Front view, mic connector - 4 pins are fine, marked 1 
- 4.
There is a dot indicating connection to the body of connector, not marked. 
Schematic doesn't show any connection to the body of connector, but there is 
connection to the chassis gnd.

Page 10 shows Figure 2-4 Microphone wiring for Orion.
Appears mike connector with corresponding numbering of pins is wired to some 
kind of microphone? Box showing MIC ELEMENT and PTT. Pin 4 supposed to +9VDC 
is wired to case (grounded?) and PTT common contact. Pin 3 to PTT N/O. What is 
that supposed to be?  (How not to wire? :-) I have no problem with mike wiring.

Figure 2-5 Proper mic cable wiring, shows connections between (what?) 
MICROPHONE and TRANSCEIVER.
PTT wire goes between pins 3 on both connectors, 4 is free.
Then we have pins 1 and 2 cross wired between two connectors. Why? Pin 2 is 
supposed to be ground and normally tied to the ground on radios and mikes or 
could be floating at the microphone, with case/body tied to the ground 
connection at the mike or cable connector. 
Then we have shield of the cable connected only to the body of connectors. 
How do you provide connection to the shield? Just clamp it at the connector 
body? That is not a good practice, things corrode, loosen up. If there was 
solder 
connection to the body of connector, then its OK, but those 4 pin connectors 
do not have solder lug for the body.  Not very good practice, prone to 
problems. MIKE connector body seems to be connected to radio's GND.
So what is it, messed up diagrams or any special reason for it?

I used my old OMNI VI adapter from 4 pin connector to two dingles, one for 
Heil mike connection wired between pin 1 and 2 (gnd, shield) and one for PTT 
between pin 3 and 2 (gnd, shield). Now I can send CW with my foot using PTT/CW 
"feature" :-)

I am asking here first, in case I am off the rocker, before I bother busy 
people at TT.

Yuri, K3BU 
5x tentecker
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>