Sounds like something has upset the settings of the COM port you use to
control the radio.
Check the settings for the COM port, if nothing seems out of whack, remove
the port from Windows' knowledge and restart the computer.
Windows will auto detect the "new" COM port on next start.. except Windows
3.xx and 95 where you will have to manually add the port again after removal
and restart.
Just in case..
To remove the port, the route is Start > Control Panel > System > Device
Manager Tab and then scroll down the list to Ports. Double click the
offending port and remove it.
Paul MW0CDO
----- Original Message -----
From: "J. D." <duffyb01@fuse.net>
To: <tentec@contesting.com>
Sent: Saturday, November 15, 2003 4:27 PM
Subject: [TenTec] New TenTec Software and N4PY Issue
I downloaded the new TenTec Pegasus 32 bit software to play with and
installed it on my "ham only" computer. Nothing exciting, but I did notice
that the frequency display acted very jumpy and would only change digits as
the seconds ticked away on the clock display. The analog bar would also
jump around and may go up as I dialed the freq down and vice versa.
So I uninstalled the new TenTec software. Now, the N4PY software does
almost the same thing. The freq display only changes as the clock display
seconds change. However, the analog bar underneath does not have the same
problems as the new TT software had.
Any one else have these issues? Can't understand why the TT installation
would effect the N4PY installation.
Regards,
Duffy
www.wb8nut.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|