The programmable AGC works fine on the latest version of the firmware. However,
a couple of times in the past I have had glitches on download that caused
loading hangups or other problems.
When that happens I reload the previous version and check to make sure nothing
has happened in the rig. Then I delete the latest upgrade, download it again,
and reinstall. So far, keeping my fingers crossed, the second time's been a
charm.
73 Pete Allen AC5E
> I downloaded and installed Orion firmware 1.366 earlier today while I was
> getting my station ready for Charlie K1XX to use in SS. While checking the
> various menu parameters afterwards I noticed that I could not set the Main
> RX programmable AGC decay below 80 dB/s. I had not problem setting the Sub
> RX programmable AGC to 20 dB/s (the recommended "contesting" setting per the
> Orion Optimize document that Ten-Tec published last summer), but I could not
> get the Main RX to go there.
>
> Is this a bug or am I doing something wrong?
>
> 73,
> Bill NT1Y
>
> _______________________________________________
> Orion mailing list
> Orion@contesting.com
> http://lists.contesting.com/mailman/listinfo/orion
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|