Re: [TenTec] T/R isolation measurement on Corsair 1

["Stuart Rohre" <rohre@arlut.utexas.edu>]

Probably you need to load the aux antenna connector on the Corsair with a
typical antenna impedance in order to see full TR isolation values.  The
scope probe is such high impedance that it will give a lower level of
isolation measurement.  As a general rule to measure isolation of any ported
network, all ports have to be loaded to specified impedances for operation.
-Stuart
K5KVH


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec