John;
I only have an Omni 6+ so this doesn't affect me, but I though I saw
somewhere that the older Centurion's need a mod to work correctly with the
newer rigs. (Pegasus, Jupiter, Orion). Searching the Ten Tec site under the
Centurion info, I found :
Note for older 422 Centurion amp owners: Using an older Centurion with the
newest Ten-Tec HF transceivers - Pegasus, Jupiter, and Orion - may require a
small modification to the QSK board in older Centurion amps for proper QSK
CW keying. Short diode D2 (red diode, 1N4148, next to Q1) with a jumper
wire. The current 422B does not require this modification.
I wonder if that is your problem?
73
Harry, NK9R
----- Original Message -----
From: "john, ke5c" <ke5c@hot.rr.com>
To: "Ten-Tec Reflector" <tentec@contesting.com>
Cc: <service@tentec.com>
Sent: Saturday, November 22, 2003 10:48
Subject: [TenTec] Orion/Centurion/Ant1 QSK Question
> The Orion has arrived, but has anyone run across this before?
>
> 1) Omni 6+ keys Centurion in QSK mode fine
> 2) Orion/Ant1/KeyingLoop1=ON puts Centurion into transmit mode but Orion
> does not go into transmit as if loopback to Orion not working properly,
yet
> 3) With a direct loopback - TX OUT 1 jumpered to TX EN 1 - the Orion does
go
> into transmit, and
> 4) Orion/Ant2/Keying Loop2=ON works fine.
>
> Without a circuit diagram, I am guessing the output device that drives TX
> OUT1 is weak (low beta) so that it can sink enough current to key the
> Centurion but not enough to then also key the Orion. Or perhaps however
the
> Orion senses a closure or low level for TX EN1 is a bit off. Thanks for
any
> thoughts.
>
> 73, John
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|