TenTec
[Top] [All Lists]

Re: [TenTec] Omni V - sidetone/headphone problem?

To: <tentec@contesting.com>
Subject: Re: [TenTec] Omni V - sidetone/headphone problem?
From: "Bill Fulling" <w4njf@email.midflorida.com>
Reply-to: tentec@contesting.com
Date: Thu, 5 Feb 2004 16:35:55 -0500
List-post: <mailto:tentec@contesting.com>
Hi Carl,
Am having a few problems with ur program(per se);had to reload XP again on
this system to get OE-6 to work-
this has a chronic pain the butt w/XP pro.Got it reloaded with ur program
(and all ham radio programs loaded on slave drive "D"). After reloding the
master drive "C" with a refresh of win XP pro,shut down and rebooted after
replugging drive "D" back in.Well ur program sez I need another password,got
an install #23313 .This is getting to be a REAL PAIN IN THE ASS!
Ur program on Drive "D" was NOT disturbed(It was disconnected during the
"master re-load" and reconnected after shut down and re-boot !).
What's the problem here? If I  upgrade the memory am I going to have to go
thru this drill again?Pls advise.
Can ur system be configued to run concurrently with PSKse ver 2.23 w/o using
Vox?Would like to use the mouse click to enable the PTT line on the Jupiter
and not have to putz around w/vox settings.
EG-my control cable to my Jupecan be broken  amidships(couldn't get a 12'
cable-had to get two).
can I make a "breakout box" and access the RTL/DTS lines and system gnd,or
am I stuck putzing around w/Vox?Tried enabling a separate Com port (com 3)
and tried synching it with ur program,but no luck.Got any suggestions?
73 de Bill W4NJF

----- Original Message -----
From: "Carl Moreschi" <n4py@earthlink.net>
To: <tentec@contesting.com>
Sent: Thursday, February 05, 2004 8:30 AM
Subject: Re: [TenTec] Omni V - sidetone/headphone problem?


> Add a 100 ohm resistor in series with the headphones.  This will even out
> the headphone volume to the speaker volume.  You can add this resistor
right
> into the headphone plug from your headphones.
>
> Carl Moreschi N4PY
> Franklinton, NC
> ----- Original Message -----
> From: "james murray" <jmcm@capital.net>
> To: <tentec@contesting.com>
> Sent: Thursday, February 05, 2004 5:43 AM
> Subject: [TenTec] Omni V - sidetone/headphone problem?
>
>
> Picked up a nice used Omni V and very impressed with it so far.  One
problem
> I came up with is that when I put the headphones on the first time the
> sidetone rattled my eardrums a bit.  In order to use headphones I had to
> turn the sidetone all the way down.  When I pull the phones out sidetone
is
> barely audible.  Headphones are
> Yaesu YH-55, 8ohm.  Manual says 4-16 ohms.  Any ideas.
> tnx,
> Jim/k2hn
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>