Re: [TenTec] Wire guage

[Tim Soxman <tims@hhs.net>]

OK guys,
Here it is, get it at Wholesale tool Inc, www.wttool.com :

Standard thickness gages, 3 5/16 Diameter X No 10 thickness.  Each slot 
is numbered with decimal equivalent on back.  Hardened.
Us standard gage for wire, sheet, plate sizes, non-ferrous metals.
Model 950-202 Order No 1289-0005  16.95 each.
73
Tim W3ZVT

Steve Weber wrote:

> If a source is found, would you please post to the list?  We had one at my former emplyer (now in China) and it vanished into someone's toolbox.  Unfortunately not mine!
>
> 73 de KD9BO Steve
>
>
> On Wednesday, March 24, 2004, at 04:38PM, Bill Fulling <w4njf@email.midflorida.com> wrote:
>
> > Hi folks,
> > Many years ago when I was in the Navy we were issued in our ET toolboxes a wire 
> > guage-it was about 2 1/2' in diameter and was used sort of like a spark plug 
> > gapper-was used to ID the AWG diameter of unknown wires(go-no go).Does anyone 
> > know if these are still available;I'd like to buy one.
> > 73 de Bill W4NJF
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec