| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] Corsair II question on filters |
| From: | "J. W. (Dub) Thornton" <dub@oklahoma.net> |
| Reply-to: | tentec@contesting.com |
| Date: | Sat, 27 Mar 2004 22:19:40 -0600 |
| List-post: | <mailto:tentec@contesting.com> |
|
Jim: As you have it identified, the vertical filter is the stock 9mhz I.F.
2.4khz The other 4 filters are in the 6.3mhz second I.F. Pos #1 was 2.4khz Pos #2 is for 1.8khz Pos #3 is for 500hz Pos #4 is for 250hz Three position xtal filter switch on front panel: If you are in SSB mode, #3=2.4khz filter #2=1.8khz #1=500hz If you are in CW mode, #3=1.8khz #2=500hz #1=250hz Good luck with the rig, its a nice one. "73" Dub At 08:30 PM 3/27/2004, you wrote: I just acquired a Corsair II but have no manual yet (and they are expensive). My question: -- J. W. (Dub) Thornton WA5YFY Minco, OK. _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Omni VI low TX power, OTAKEBI |
|---|---|
| Next by Date: | Re: [Tentec] Corsair II question on filters, Allan Taylor |
| Previous by Thread: | [TenTec] Corsair II question on filters, Jim Larsen - AL7FS |
| Next by Thread: | [TenTec] Corsair II questions, Jim Larsen - AL7FS |
| Indexes: | [Date] [Thread] [Top] [All Lists] |