N4LQ posted: "Yesterday I was almost finished with a qso and everything
went nuts. I had to 'reboot' and I was not in the split mode either. This
morning I lost receive audio a couple of times but it suddenly returned. I
went ahead an did a full reset just to flush out any bugs."
I am running v1.369 and have been bothered by the following bugs:
(1) Sub RX audio has buzzsaw noise but no signals
(2) VFO A will not tune Main RX but does receives signals OK (if it happens
to be tuned to a frequency with a signal)--turning the VFO knob does not
change the RX frequency although the frequency readout does change.
In both cases, cycling the rig's power cures the fault (temporarily).
I cannot ascertain any particular rig state that triggers these faults. I
do, however, tend to use the band scope.
73,
Bill NT1Y
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|