TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI+ filter question

To: tentec@contesting.com
Subject: Re: [TenTec] Omni VI+ filter question
From: Clark Savage Turner <csturner@kcbx.net>
Reply-to: tentec@contesting.com
Date: Tue, 25 May 2004 20:51:49 -0700
List-post: <mailto:tentec@contesting.com>
Hi Tim -

Yes, you'll need the pair so that the PBT operates properly and the audio passband is widened. Both SSB filters are in line for PBT operation. I have jumped the 6.3 MHz filter before with a resistor and just had a single filter in the 9 MHz slot (lose PBT) but the hiss comes way up and its not quite what I wanted.

A pair of 2.8's and the INRAD mod to the audio board will give you a bit wider audio, but it won't be "full" audio. I think there are lots of sites that discuss receiver bandwidth for the Ten Tec rigs (check out our friend in Albany :-)

Clark
WA3JPG


On Tuesday, May 25, 2004, at 08:25 PM, <nz7c@cox.net> wrote:


Hi folks -
I have an Omni VI+ on the way. I'm not clear on one thing. Are BOTH the 2.4 standard filters always cascaded together? If so, I guess that means you would have to buy a 2.8 filter for each board if you wanted to widen the SSB. Or can you cut out one filter and thus only need to buy one 2.8 for the 9Mhz board Thanks in advance.
73/Tim NZ7C


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>